Please select an airport
Budapest - Liszt Ferenc
London - Heathrow
Warsaw - Chopin
Seattle-Tacoma Intl.
Please select a difficulty
Easy
Normal
Rush hour
Please select a game mode
Arrivals & Departures
Arrivals only
Departures only
Thanks for trying out my ATC simulator!
Your final results are below:
Successful landings:
Successful handoffs:
Missed approaches:
Improper exits:
Separation violation:
sec
Back to Start Page
Airport
ICAO: | IATA:
Elevation:
Commands consist of 2-5 parts divided by space(s). First part is the flight number (e.g. "AA001") Followed by the clearance type and its parameters as below: - "A" to change ALTITUDE followed by the required altitude in 100 feet beetween 20 and 400. (e.g.: AA001 A 40) - "S" to change SPEED followed by the required speed in 10 knots between 16 and 30. (e.g.: AA001 S 20) - "H" to change HEADING followed by either the required heading direction in degrees (1-360), where 360 is North, 180 is South (e.g.: AA001 H 150) or the destination navigation object. (e.g.: B H wOD) For instructing an aircraft to start holding procedure at a navigation object write an additional "HP" after the navigation object code. (e.g.: AA001 H WOD HP) - "L" to clear an aircraft for LANDING followed by the runway ID. (e.g.: AA001 L 27L) Landing clearance must only be given when an aircraft's actual heading is within 20 degrees that of the chosen runway angle (its ID * 10) and when the aircraft is not higher than 4000 feet! - "T" to clear an aircraft for TAKE-OFF. (e.g.: AA001 T 27L WOD 80) Following "T" type the runway intended for take-off then the exit navigation object shown on the flightstrip and finally an hand-over altitude. (Note: In case the aircraft exits anywhere else other than the nav. object indicated it will count as an improper exit.) - "W" to clear an aircraft for LINING-UP AND WAITING on the runway before take-off. (e.g.: AA001 W 27L WOD 80) This option is mainly for busy periods. Similarly to the take-off command, after "W" type the runway intended for take-off then the exit navigation object indicated and the hand-over altitude. When an aircraft is given a waiting clearance already, for take-off clearance only type the flight ID and "T" as the exit parameters will be remembered. (e.g.: AA001 T) Additional commands: - Press "P" to PAUSE/RESUME the simulation. - Type "EXIT" or press "End Simulaton" button to exit the game. Your final statistics will be shown. Notes: Aircraft need to be separated by at least 3NM laterally and 1000 feet vertically.